Contact Us

Tel:+86-510-83789063

Fax:+86-510-82603256

E-mail:jane@inoco.cn

Add: No.58, Furong Industrial Park, Xishan Economic Technology Development Zone, Wuxi, China

Home > Knowledge > Content
Replacing filter element Dec 27, 2017

1.1 The membrane filter cartridge should be replaced regularly. The cycles of replacing element are as below.

I. Security filter’s  Water consumption is Significantly lower than before, or the existing pressure is lower than the initial pressure 50kpa, it needs to change filter element  one time within three months.

II. Resin filter’s  Water consumption is Significantly lower than before, or the existing pressure is lower than the initial pressure 50kpa, it needs to change filter element  one time within three months.

III.Micron membrane filter’s  Water consumption is Significantly lower than before, or the existing pressure is lower than the initial pressure 50kpa, it needs to change filter element  one time within three months, usually the filter precision can reach 0.45 micron.

IV.Pure water terminal’s membrane fluid filtration systems  Water consumption is Significantly lower than before, or the existing pressure is lower than the initial pressure 50kpa, it needs to change filter element  one time within three months, usually the filter precision can reach 0.22 micron.

图片2.jpg

1.2 How to replace the filter cartridge

Open the plastic bag on the cartridge opening end, check whether the gasket is in good condition and in place. Use a suitable wetter (e.g. water) to wet the gasket and the cartridge socket.The hand should hold the end which is close to the O-ring, and insert the cartridge interface into the cartridge socket vertically.Remove the packing bag of cartridges after all cartridges are inserted in place. And then fix the pressure board, install the metal casing in place.http://www.inocofiltration.com/